🤿 How To Remove Finish From Guitar

The final smoothness of your guitar and surface will not be determined solely on the final grit you use, but also by the finish. Somewhere around the 400-600 grit, the surface is smooth to the point where the grain plays just an important part to the overall smoothness and the effect it will have on the finish as the sanding itself. First, wet the guitar body with a little bit of moisture to ease the application of the stain and prevent blemishes. Apply the stain following manufacturer instructions, and apply as many coats as needed to achieve the look you're after. 9. Apply a clear coat to the guitar. Again, nitrocellulose is recommended. Sand the guitar neck with 600 grit sandpaper to smooth the surface. Apply clear sealer on the neck using a towel. Wait till dry. Apply another coat of the sealer up to 5 coats. Rub with 0000 steel wool to smooth the surface. Transparent sealer is perfect if you like the looks of unfinished guitar. The 3M adhesive used on pick guards is just that - adhesive only. It likely stuck to the gloss finish of the CEO-7 better than the satin finish of the 15 Series guitars, so most of it stayed with the guitar rather than the guard. Use naphtha (or bottled lighter fluid) to remove it. I would not put paint thinner on lacquer. It will also remove the sticky sensation from your neck. Only use the 0000 steel wool and leave the rest for later. If you use more aggressive steel wool (000 or 00) you will most likely rub against the protective satin finish. The guitar’s finish should be removed. This guitar neck is made of Fender Telecasters from the early 1970s. Once the fretboard is clean, run the pad up and down along the top of the frets to polish them. After cleaning the fretboard with steel wool, use a vacuum to carefully remove the steel fibers that inevitably shed from the pad (Fig. 7). Avoid getting the fibers on the guitar's finish, as they can scratch it. Prepare an application rag from well-washed, lint-free white cotton, about 8″ square. Fold the rag so all the ripped edges are in the center to keep lint out of the finish. Ball up the rag so the wiping varnish isn’t absorbed too much. You should end up with a flat, smooth applicator surface of about 3″ square. Apply the polish to a cloth then rub over the guitar’s body. Smooth the polish around an area with the cloth, then with a clean section of the cloth, or a separate cloth, rub any excess polish off and rub into the surface. A few coats may be needed. The polish then needs to be buffed in to finalize. EvK24u.

how to remove finish from guitar